Nailer Hose
June 11th, 2011
For a Porter Cable Brad Nailer, where do I add the oil?
In the manual, they said to add 5 drops to the gun. Do I put the drops directly inside where the gun connects to the hose? ( The male end)
After I add the oil, is it ok to hook the gun directly up to the air compressor to use it?
thanks
Put the oil drops in in the inlet airport (where the air hose connects). Yes, you can start using the gun after the oil is added. However shoot the gun a few times on a scrap piece of wood so the excess oil will blow out. If you don’t oil may get on your good wood thus causing a stain and difficult if not impossible to remove or cover over depending upon your finish.
|
|
25 ft. x 1/4″ Air Hose for Roofing and Framing Nailers $19.99 |
|
|
PASLODE IMPULSE 1M250 SOLID STATE FINISH NAILER BRADS HOSE LESS NAIL GUN NICE $99.99 |
Categories: Used Construction Equipment cfm, nail, nailer hose, nailer hosein, nails, nv45ab2, roofing